These images from NASA's Dawn spacecraft are located in asteroid Vesta's Tuccia quadrangle, in Vesta's southern hemisphere.
Add image to your album
Email this page Post this page to your Facebook wall Tweet this page

HAMO and LAMO Images of Antonia Crater

These Dawn framing camera (FC) images of Vesta show Antonia crater at both HAMO (high-altitude mapping orbit) and LAMO (low-altitude mapping orbit) resolutions. The left image is the HAMO image and the right image is the LAMO image. Antonia is the large crater that dominates the LAMO image. The LAMO image is approximately 3 times better spatial resolution than the HAMO image. In images with higher spatial resolutions smaller objects can be better distinguished. Antonia crater was identified as an unusual crater from the HAMO images but the LAMO image of Antonia is spectacular. Most of Antonia has a sharp rim with finely spaced gullies running around the crater below the rim. There are also subtle variations of the brightness of the material in Antonia visible in the LAMO image. The LAMO image also highlights the boulders and mottled appearance of the slump of material on Antonia's left side. The ridged morphology of the material outside of the right rim of Antonia is also made clearer in the LAMO image.

These images are located in Vesta's Tuccia quadrangle, in Vesta's southern hemisphere. NASA's Dawn spacecraft obtained the left image with its framing camera on Oct. 24, 2011. This image was taken through the camera's clear filter. The distance to the surface of Vesta is 700 kilometers (435 miles) and the image has a resolution of about 69 meters (226 feet) per pixel. This image was acquired during the HAMO (high-altitude mapping orbit) phase of the mission. NASA's Dawn spacecraft obtained the right image with its framing camera on Dec. 21, 2011. This image was taken through the camera's clear filter. The distance to the surface of Vesta is 272 kilometers (169 miles) and the image has a resolution of about 25 meters (82 feet) per pixel. This image was acquired during the LAMO (low-altitude mapping orbit) phase of the mission.

The Dawn mission to Vesta and Ceres is managed by NASA's Jet Propulsion Laboratory, a division of the California Institute of Technology in Pasadena, for NASA's Science Mission Directorate, Washington D.C. UCLA is responsible for overall Dawn mission science. The Dawn framing cameras have been developed and built under the leadership of the Max Planck Institute for Solar System Research, Katlenburg-Lindau, Germany, with significant contributions by DLR German Aerospace Center, Institute of Planetary Research, Berlin, and in coordination with the Institute of Computer and Communication Network Engineering, Braunschweig. The framing camera project is funded by the Max Planck Society, DLR, and NASA/JPL.

More information about Dawn is online at http://www.nasa.gov/dawn and http://dawn.jpl.nasa.gov.

Image details

ID#:
PIA15904

Date added:
2012-08-09

Target:
Vesta

Mission:
Dawn

Spacecraft:
Dawn

Instruments:
Framing Camera

Size:
2550 x 1500 pixels (width x height)

Rating:



Views:
1,478

Full-Res TIFF:
PIA15904.tif (3.83 MB)

Full-Res JPG:
PIA15904.jpg (0.27 MB)

Image credit:
NASA/JPL-Caltech/UCLA/MPS/DLR/IDA