Unusual Fault Pattern Surfaces in Earthquake Study

3-D view of the surface rupture of the 2010 El Mayor-Cucapah earthquake This 3-D view of the surface rupture of the April 4, 2010, El Mayor-Cucapah earthquake (red line) reveals a new fault line connecting the Gulf of California with the Elsinore fault, which could become a major part of the boundary between the Pacific and the North America Plates. Image credit: Caltech Tectonics Observatory
› Larger image
  • submit to reddit

August 11, 2011

PASADENA, Calif.- Like scars that remain on the skin long after a wound has healed, earthquake fault lines can be traced on Earth's surface long after their initial rupture. Typically, this line of intersection is more complicated at the surface than at depth. But a new study of the April 4, 2010, El Mayor-Cucapah earthquake in Baja California, Mexico, reveals a reversal of this trend. Superficially, the fault involved in the magnitude 7.2 earthquake appeared to be straight, but at depth, it's warped and complicated.

The study, which was led by researchers at the California Institute of Technology with NASA Jet Propulsion Laboratory geophysicist Eric Fielding serving as a coauthor, is available online in the journal Nature Geoscience.

In a standard model, transform plate boundary structures -- where two plates slide past one another -- tend to be vertically oriented, which allows for lateral side-by-side shear fault motion. However, as the study found, the 75 mile (120 kilometer) long El Mayor-Cucapah rupture involved angled, non-vertical faults and the event began on a connecting extension fault between the two segments.

The new analysis indicates the responsible fault is more segmented deep down than its straight surface trace suggests. This means the evolution and extent of this earthquake's rupture could not have been accurately anticipated from the surface geology alone, says the study's lead author Shengji Wei. Anticipating the characteristics of earthquakes that would likely happen on young fault systems (like the event in the study) is a challenge, since the geologic structures involved in the new fault systems are not clear enough.

Jean-Philippe Avouac, director of Caltech's Tectonics Observatory and principal investigator on the study, says the data can be used to illustrate the process by which the plate boundary -- which separates the Pacific Plate from North America -- evolves and starts connecting the Gulf of California to the Elsinore fault in Southern California.

Read the full story on the Caltech website at https://mr.caltech.edu/press_releases/13443.

Written by Katie Neith

Whitney Clavin/Alan Buis (818) 354-4673/(818) 354-0474
Jet Propulsion Laboratory, Pasadena, Calif.
whitney.clavin@jpl.nasa.gov/ alan.d.buis@jpl.nasa.gov



Horizontal motion of the 201 Baja California earthquake

Horizontal motion measured from radar images reveals the faults that moved in the magnitude 7.2 earthquake in Baja California, Mexico. Image credit: JAXA/METI/NASA/JPL-Caltech
› Larger image

enlarge image

NASA's UAVSAR Studies Ground Deformation from Napa California Quake NASA Research Aids Response to California Napa Quake

› Read more

NASA's C-20A Earth science research aircraft with the UAVSAR NASA Radar System Surveys Napa Valley Quake Area

› Read more

Superstition Hills fault movement California Faults Moved Quietly After Baja Quake

› Read more

Get JPL Updates
Sign Up for JPL UpdatesRegister today and receive up-to-the-minute e-mail alerts delivered directly to your inbox.
Sign Up for JPL Updates